Skip to main content

VoiceTracer (DVT2110, DVT2810)

Get started

Caution

Before you connect your VoiceTracer, first read the safety instructions (see Safety instructions).

Charging the battery

  • Charge the built-in battery before you use the device for the first time or if you haven’t used it for an extended time period.

  • If the battery is completely discharged and your device turns off, allow the battery to charge for a while before you turn on the device.

  • A complete charging cycle takes about 3 hours.

  • The device should be charged every 6 months even when not used, to prevent the battery from completely draining (deep discharge).

Note

  • Before you charge the battery via computer, make sure that your computer is turned on.

  • While the device is connected to a computer, it can’t be operated manually.

  • When the low battery icon VoiceTracer battery icon is displayed, charge the device promptly.

  • If you charge your device via computer instead of using a power supply unit, the charging speed might slow down due to a lower charging current. For fast charging, use a USB power supply unit (not included).

VoiceTracer USB connect

X A charging battery icon appears on the screen and the Record/Status LED flashes orange for a few seconds.

Turn the device on and off

To turn the device on or off:

  • Slide and hold the Power switch on the right side of the device downwards for three seconds.

dvt2110_turn-on.svg

Key lock

You can lock your device when it’s active to prevent any unwanted device operations or access.

To lock the device:

  • Slide the Power switch on the right side of the device upwards towards the lock symbol.

    X The lock symbol appears on the screen for a moment.

    X All buttons are locked now.

To unlock the device:

  • Slide the Power switch downwards.

    X The unlock symbol appears on the screen for a moment.

Connect to a computer

You can use your recorder as a USB mass storage to conveniently store, back up and move files. Link the device to a computer with a USB cable. Your recorder will automatically be recognized as a mass storage device. You don’t need to install any software.

For more information on how to connect your device to a computer, see the illustration in Charging the battery.

Caution

Don’t disconnect the USB cable from the device while you are transferring files. This might cause data loss.

Note

While the device is connected to a computer, it can’t be operated manually.

Set the date and time

You can always change the date and time as well as the time format on your device.

  1. In stop mode, press the Right function button VoiceTracer settings icon to open the settings panel.

  2. Press the Record button to select All settings.

  3. Press the Right function button to enter the Device settings.

  4. Press the Down button to navigate to Date & time and then press the Record button to confirm.

  5. Press the Up/Down buttons to navigate to your desired setting Date, Date format, and Time. Use the Forward and Backward buttons to change your desired setting.

  6. Press the Record button to confirm your settings.

  7. Press the Back button to return to the stop mode screen.

Set the device language

You can always change the language of your device.

  1. In stop mode, press the Right function button VoiceTracer settings icon to open the settings panel.

  2. Press the Record button to select All settings.

  3. Press the Right function button to enter the Device settings.

  4. Press the Record button to select Language.

  5. Press the Up/Down buttons to navigate to your desired language, and then press the Record button to confirm your selection.

  6. Press the Back button to return to the stop mode screen.